RC Receiver tester
No description available.
Wireless Coupled Scanning Voltmeter (ATMega8)
A 10 bit scanning voltmeter with a Minimum Mass Wireless Coupler, based on the ATMega8. Range to the Minimum Mass Base Unit is 10 to 15 cm. If the voltmeter is battery operated, it can be floated from ground. This...
Bandswitched Grid Dip Meter
This circuit is designed for checking resonances in tuned circuits, antennas, and similar applications, covering a frequency range of 2 to 20 MHz. Q1 acts as an oscillator that can be tuned across this range using capacitor C1 and band-switched...
A Simple 80M Direct Conversion Receiver
A few weeks ago, Jason NT7S mentioned the ZL2BMI DSB transceiver as a rig that might be of interest for building. He was correct; it had been seen in SPRAT, but for some reason, it had not been seriously considered...
A Low Power Wireless Audio Power Amplifier circuit
This low-cost project enables audio reproduction from a television without disturbing others. It eliminates the need for wired connections between the TV and loudspeakers. Instead, it utilizes invisible infrared light to transmit audio signals from the TV to the loudspeakers....
3-Wire Receiver/Message Demuxer
This 3-wire receiver verifies the initial four data bits of 16 received bits against a predetermined address. If the two match, the remaining 12 bits are stored in two 6-bit flip-flop registers. The design can utilize either CMOS or TTL...
Garage door open indicator
There are battery-powered wireless systems available, but the ones encountered would indicate that the door was open even if it was left ajar for ventilation. A system was desired that would alert when the door was fully raised. Additionally, it...
Intelligent home lighting control switch transmitter and receiver circuit
This design aims to create a long-distance wireless remote control switch lighting control system, which consists of a transmission system and a reception system. The system utilizes wireless transceiver modules for RF transmission and reception. The transmitting portion mainly comprises...
Wireless Coupler Terminal Interface
The purpose of the terminal interface is to allow my computer to communicate with Minimum Mass Wireless Coupler equipped devices using a terminal emulator program. Consequently, the Base Unit is basically an RS-232 interface and Minimum Mass Wireless Coupler. The...
RF Inductance Meter
This RF inductance meter measures RF chokes in the 500 nH to 50 µH range. A simple solution was required to measure hand-wound RF inductors in a secondary lab setting. The user intended to utilize this device occasionally and did...