Automatic light for Car
No description available.
light activated led
This project involves a simple and engaging light-activated LED circuit that illuminates an LED in response to light exposure. The circuit is straightforward to construct, requiring only six components. A photoresistor is utilized for light sensing, while a 2N2222 transistor...
LED VU Meter with LM3914N
The circuit utilizes an LM3914N bar graph display driver (IC1) to control up to ten LEDs. It is configured such that when 0V is applied to the input, only the first LED indicator lights up. This straightforward peak reading VU...
Simple power Supply for LEDS
LEDs are great display tools. Their prices have decreased to a point where they are replacing more conventional light sources. In one sense, their characteristic need for low voltages is an advantage, e.g., compatibility with I.C. drives, but this voltage...
led workbench lighting
A highly practical workbench lighting unit designed for electronics hobbyists. The portable inspection lamp circuit features an onboard voltage regulator and a high-brightness 5mm white LED. It can be powered by any 9 to 18 volt DC-rated AC mains adapter...
LED DRIVER
An input sine wave applied to the left amplifier base results in the collector output fluctuating above or below 6.6 volts. The amplifier amplifies and inverts the signal, maintaining a roughly centered output, thereby minimizing the chances of clipping. The...
LED Audio Level (VU) Indicator and Alarm: The Dot Turns to Bar When The Signal Reach The Maximum Le
This LED (Light Emitting Diode) display consists of 10 LEDs to indicate the level of an input signal. If the signal is low, only LED #1 will light up. As the signal level increases, the illuminated dot will progress through...
LED Audio Power Indicator
This circuit is intended to indicate the power output level of any audio amplifier. It is simple, portable, and displays three power levels that can be set to any desired value. IC1A is the input buffer, feeding 3 voltage comparators...
led traffic lights
The LED traffic light circuit manages six LEDs (red, yellow, and green) for both north/south and east/west traffic directions. The timing sequence is produced using a CMOS 4017 decade counter in conjunction with a 555 timer. Outputs 1 through 4...
One light emitting diode display circuit
Light-emitting diodes (LEDs) can be powered using direct current (DC), alternating current (AC), and pulse drivers. A typical buck LED display circuit is illustrated in Figure 13-1. The current-limiting resistor (R) for LED tubes can be calculated using the following...