Results tagged #Peak Detector in Circuits

A Peak Detector is any circuit that functions to detect the peak voltage of an incoming waveform. Basically the circuit is used as an Amplit...

I tried the circuit below, but i couldn`t make the output.. Plz help me with corrections. In schematic: Resistors - 10k capacitor - I tried ...

The circuit uses a dual operational amplifier IC, the 1458, which is a single IC package that houses two individual op-amps. In this circuit...

This closed-loop peak detector circuit uses a Schottky diode inside feedback loop to obtain good accuracy. The 20- resistance RQ isolates t...

An analog signal requires about 100 ns to propagate through the HA-5320. For time-varying signals, this assures a voltage dif...

A 0-to-5 V input drives the negative input of LM392 comparator if reset (pin 12) if DC4060BE is pulled high then low, all out...

This circuit will allow a multimeter to display the positive or negative peaks of an incoming signal. A 741, JC1, is used in the noninverti...

This peak detector uses a CA3100 BiMOS op amp as a wide-band noninverting amplifier to provide essentially constant gain for a wide range o...

This circuit can detect the positive peaks for signal frequencies higher than 5 MHz. It yields ±1% accuracy for 400 mV to 4 V pk-pk sign...

The high-speed peak detector uses a highly accurate, fast s/h amplifier controlled by a highspeed comparator. The s/h amplifier holds the ...

The peak detector tracks and holds, using the charge-storing ability of a capacitor, the highest output voltage from a transducer. Initiall...

ICl and IC2 form an inverting half-wave precision-rectifier/peak-detector circuit. Negative input-signal, swings with peaks larger than the...

If the voltage at the input exceeds the voltage on the capacitor, then the output of the 741 goes positive, the diode conducts, and the capa...

If subsequent input voltage exceeds that stored in Cl, the comparator voltage will go high and charge Cl to new higher peak voltage. ...

The purpose of the circuit is to hold the peak of the input voltage on capacitor Cl, and read the value, V0, at the output of U2. Op amps Ul...

National Semiconductor's DP8464B is primarily intended for use in disk systems as a pulse detector. However it can be easily used as a gener...

Circuits are easily implemented using the CA3130 BiMOS op amp. For large-signal inputs the bandwidth of the peak-negative circuit is less th...

This is a handy companion for a digital voltmeter. Its allowed me to do a lot of things I used to use my oscilloscope for, and in addition i...