triangle square wave generator 2
#wave generator
#triangle wave
#square wave
#signal generator
#oscillator
#function generator
#waveform
#electronics
#circuit design
No description available.
Last-cycle-completing-gated-oscillator
Regenerative feedback at capacitor C allows the oscillator to complete its timing cycle instead of shutting off immediately. The integrated circuit (IC) used was a CD4011AE, although an equivalent IC will also function.
The described circuit utilizes regenerative feedback to enhance...
Function Generator
Using an Intersil ICL8038, this function generator produces frequencies ranging from 1 Hz to over 80 kHz. R1 is the fine frequency control, while S1 is the coarse frequency control range switch. S2 selects the output waveform as square, triangle,...
RF Signal Generator
This signal generator is designed for the realignment of radio receivers. It is an economical and straightforward unit, adequate for its intended application. However, the output is not a pure sine wave, which may limit its suitability for more precise...
Rectangular/Triangular Waveform Converter
Many function generators utilize a rectangular waveform generator that comprises a Schmitt trigger and an integrator. The triangular signal generated by the integrator is subsequently transformed into a sinusoidal signal using a diode network. The converter described here operates inversely,...
Square wave generator III
The generator described is designed for generating multiburst square waveforms and can be utilized to characterize the response of television monitor amplifiers. The circuit functions as an RC oscillator using NAND gates (IC4-4011), with the capacitor C periodically altered by...
LC square wave generator
A square-wave generator utilizing an LC circuit can achieve improved frequency stability, as illustrated in the accompanying chart. This three-terminal capacitor oscillator is capable of generating a square wave, with an operational amplifier serving as the active component.
The square-wave generator...
Test Signal Generator
This signal generator uses a three channel DAC to generate Composite video signal (CVBS) and S video signal (Y/C separated) at the same time, left one channel is not used in NTSC format. It is assigned for one of the...
Digital Function Generator (MEGA16-P)
The function generator features two BNC outputs: one for the high speed [1 to 8 MHz] square signal (BNC1) and another for the DDS signal (BNC2). Offset and amplitude can be regulated by two potentiometers: offset in range of +5V...
1KHz Square Wave Generator Circuit
This design outlines a simple 1 kHz square wave generator utilizing a few components and the LM3909 integrated circuit, which is beneficial for testing audio equipment. The circuit operates on a single 1.5V battery cell, producing a maximum output signal...