AT89C2051 Serial CMOS to LED Driver
#AT89C2051
#CMOS
#LED driver
#serial communication
#microcontroller
#embedded systems
#LED control
#digital logic
#circuit design
#electronics
No description available.
CP2128 white LED driver circuit
The CP2128 is a low-noise, fixed-frequency step-up DC/DC converter designed for garden applications. It operates within an input voltage range of 2.7V to 4.5V and can generate a stable output voltage of 5V, with a maximum output current of 100mA....
Single Zone CMOS Alarm
This circuit features automatic Exit/Entry delays, timed Bell Cut-off and System Reset. It has provision for normally open and normally closed switches and will accommodate the usual input devices such as Foil Tape, Pressure Mats, Magnetic Reed Contacts, Passive Infrared...
Eight-digit-microprocessor-display
The display interface utilizes the ICM7218A/B in conjunction with an 8048 family microcontroller. An 8-bit data bus (DBO/DB7-IDO/ID7) facilitates the transfer of control and data information to the 7218 display interface during successive WRITE pulses. The mode input pins on...
Wide Input-Voltage Range High-Power LED Driver
This is a high-power LED driver circuit designed to accommodate a wide input-voltage range. The circuit utilizes a buck/boost converter controller to regulate the current supplied to a white LED.
The high-power LED driver circuit is engineered to effectively manage varying...
Run Lights
The circuit is simple and straightforward. Two inputs are included to demonstrate input control and software debouncing. An ATMEL microcontroller AT89C2051 is utilized to control the sequential glowing of LEDs, creating a running light effect. A 12 MHz crystal is...
LM3552 white LED driver circuit design
For this LED driver electronic project, a DC power supply circuit is required to provide an output voltage between 2.7V and 5.5V. The supply voltage must be applied between Vin and GND. The T/F jumper connects the T post to...
Constant Current Source LED Drive
This is a constant current source LED driver. When the upper NPN transistor is activated by a voltage through a 4.7kΩ resistor, the LED lights up. It is assumed that the lower NPN transistor is absent. The current flowing through...
4093 Cmos Vfo Circuit
Two gates of a Quad 4093 are utilized in an astable multivibrator configuration. CI is a three-gang 365 pF variable capacitor with its sections connected in parallel. Additionally, S3 and S4 serve to switch in optional extra capacitors.
The described circuit...
LED Drivers/LCD Bias
A circuit provided by an LCD manufacturer illustrates the use of the POL signal from the display to derive the VCOM signal. It has been noted that LCD Bias ICs typically generate VCOM from a high bias voltage. The inquiry...