One-stage frequency divider
#frequency divider
#digital circuit
#logic gate
#flip-flop
#clock signal
#binary counter
#timing circuit
#synchronous circuit
#digital electronics
#frequency scaling
No description available.
Programmable Frequency Divider
This divider utilizes a variable-length shift register, a type-D flip-flop, and an inverter. The clock signal is connected to the clock input of the flip-flop, while the output of the shift register is connected to the D input of the...
Opto-Coupled RS Flip-Flop
An RS flip-flop, also known as a reset-set flip-flop, is a type of stable multivibrator that has two inputs: reset and set. The output can exist in one of two stable states.
The RS flip-flop is a fundamental building block in...
Binary counter
Stages are triggered by the positive-going edge. The silicon-controlled switch (SCS) is turned on at the cathode gate and turned off at the anode gate. The anode-to-cathode IN4009 diode suppresses positive transients while the SCS is recovering. The input stage...
Binary Up Counter Circuit with working animation and simulation video
This document discusses an Asynchronous 4-Bit Binary Up Counter, a circuit constructed from several J-K flip-flops connected in a cascade configuration to produce a four-bit counting sequence. An up counter is a digital counting circuit that increments its count sequentially....
Frequency Divider
This is a classic divider of frequency via two. It is achieved with a classic circuit T-flipFlop, round IC1 [4011]. In the circuit, the frequency of network, after are limit the negative half-s period of sine wave and transform in...
Frequency Divider For Measurements Circuit
This circuit is designed to be driven by a 1-MHz standard signal with an amplitude of several volts. The components U1 through U5 are 7490 decade counters/dividers, providing a division ratio of 100,000:1. It is possible to tap off successive...
Practical flip-flop circuit
A flip-flop circuit with a memory function for pulse signals. It features two stable states: one where transistor VTi is off and VTZ is conducting, and another where VTi is conducting and VT2 is off. An external signal is sufficient...
Flip-Flop Independent Lamp Driver
Assume first that SCR1 is on and SCR2 is off, allowing capacitor CI to be fully charged, with its LMP2 end positive. The state of the circuit can be altered by pressing switch S2. When SCR2 turns on, it capacitively...
1-20 minutes a timing circuit
The system operates between 10 minutes to 2 hours, featuring a 100-line bell controlled by a multi-gear stick labeled S2 41f. The integrated circuit (IC) functions as a self-excited multivibrator. The device can manage binary pulses ranging from 3 to...