Two-Band Tone Control
#tone control
#audio amplifier
#bass and treble
#equalizer
#audio processing
#filter
#sound adjustment
#stereo
#low-pass
#high-pass
No description available.
10 Watt Audio Amplifier
This circuit is a general-purpose 10-W audio amplifier for moderate-power PA or modulator use in an AM transmitter. With higher voltages and a change in bias resistors, up to 30 W can be obtained.
The described audio amplifier circuit is designed...
25W single-chip audio Class D amplifier IC-TDA7482
The PWM Class D audio amplifier has been the subject of exploration and reporting for over half a century. This technology is particularly attractive due to its high output efficiency, typically exceeding 85 to 90%. High output efficiency is especially...
Middle Frequency Equalizer with Parametric Feature
An equalizer is a passive or active electronic component or circuit, such as tone control, designed to modify or flatten the frequency response characteristics of a system. The NE5532 is a low-noise, dual operational amplifier that features full power bandwidth...
Mini-stereo
This circuit is constructed using two integrated circuits: the MC1458 dual operational amplifier, configured as a preamplifier, and the LM378 dual 4-watt amplifier. The gain of the preamplifier is determined by the resistor ratios R3/R1 for one channel and R4/R2...
TDA7384 class AB Audio Power Amplifier circuit design electronic project
The input capacitor is used for low-frequency cut-off, with a standard value of 0.1 µF, resulting in a cut-off frequency of approximately 16 Hz.
The input capacitor plays a critical role in electronic circuits, particularly in signal processing and audio applications....
5 Watt Class-A Audio Amplifier Circuit diagram
This solid-state push-pull single-ended Class A circuit is designed to deliver sound quality comparable to valve amplifiers, providing an output power of 6.9W measured across an 8 Ohm loudspeaker cabinet load. It features reduced total harmonic distortion (THD), increased input...
4 order filter with a single IC project PCB
High-order circuit filters are typically designed using two or more cascaded sections. This fourth-order filter requires only one operational amplifier (OA) integrated circuit (IC), which helps achieve lower distortion and reduced intermodulation. The resistor values represent the load on the...
Stereo Synthesizer
There are many ways to create a stereo effect. If you were miking a piano, a string section, or some other large sound source, you would probably stick up a pair of directional mikes and assign them left and right....
BA1451F Am Radio / Fm If Stereo System Ic
The BA3822LS, BA3822FS, BA3823LS, and BA3824LS are monolithic, five-point stereo graphic equalizer integrated circuits (ICs). Each IC features two channels, with five center frequencies for each channel that can be independently set using external capacitors. These ICs support a wide...